BEST HONDA Dio / Elite 50 Stroker 52.6mm Race Crankshaft by PG - Phongeer Motors

Description

"Got a few back in Stock
"
(Note: Crankshafts prices have gone up a lot!)
Fresh New Batch
Best 52.6mm Dio Stroker Race CrankShaft
(Set Narrow Race Bearings and crank seals included w/crankshaft)
Now with Wrist Pin Bearing!!
These Cranks retail over 0.00 and come with EXTRAs!!
Made by Phongeer Motorsports (PG)
*If you are building a 120cc to 130cc Honda Dio / Elite stroker motor. This is the BEST stroker crank
shaft for the money on the market.
*After years of R&D, these crankshafts are now available. Because of the Drag Racing races going on in Japan, Taiwan and other Asian countries in the past several years, there was a demand for this Stroker Race crankshaft for the Dio and Dio vertical type engines.
*Made for the 54mm, 55mm & 56mm Dio Stroker cylinders that need a 52.6mm stroke. This crankshaft is best Dio stroker crank out there now for the price.
*A reinforced crankshaft that has a full counter weight. Also called a "stuffer crank". The full counter weight will make more case pressure forcing more fuel into the combustion chamber.
* It also has Phenolic white inserts. This is used to lighten the crankshaft so it can rev up faster than an all metal counter weight. Phenolic is used cause it is very strong, and resistant to heat, oil and gas.
* A wider reinforced counter weight design, which uses slightly narrower race crank bearings. This is done because the longer the stroke, the closer the lower con rod pin is to the outer edge of the counter weight. In the past, if this design was not used, allot of the time the crankshaft would break under heavy stress.
(narrow race bearings are easy to find and don't cost more than Honda Bearings. We always have them in stock)
* Balance to rev 14K plus. Get up to speed quick & smooooth.
*These Race stroker cranks are made for the Honda Elite 50 (SA50) 1994~2001. Honda Dio AF27~28, KYMCO Fever ZX50, SYM DD50 and any other scoot using the Vertical Dio larger end crankshaft (will not fix small end Elite SA50 1988~1993 engines).
If you are not sure it will fit your engine, please email us before ordering.
*Crankshafts come with a set of Narrow race main bearings and a set of crank seals.
*Like ALL stroker crankshafts, the engine case has to be machined to make clearance for the larger counter weight.
* All crankshafts are inspected to make sure they are true and have no defects before sending them out.
VT Cycles Inc is Hawaii's PG (Phongeer) Agent and will ALWAYS offer the Best Prices in the USA.
NO LOCAL PICK-UPS
NOTE: Shipped to USA & Puerto Rico address Only.
"Mahalo & Stay Safe"